Adapter diagnostics
                                                                    v1.02


Running diagnostics on Intel's EtherExpress(TM) PRO/100 Smart adapter
=====================================================================

Intel's diagnostic software (SETUP.EXE) lets you test the adapter to see
if there are any problems with the adapter hardware, the cabling, or the
network.

SETUP.EXE is a DOS program and will not run under Windows* or Windows
NT*, even in a DOS session. You must boot with DOS to run SETUP.EXE.  You
will also be able to view your adapter's configuration with SETUP.EXE.

It's a good idea to run diagnostics every time you install an adapter.
You can also use diagnostics to isolate problems during troubleshooting.

1  Restart your computer without loading drivers.

2  Insert the Intel Configuration and Drivers diskette into a drive,
   switch to that drive, and at the DOS prompt, type:
      
      SETUP

   If you have more than one adapter installed, a Board Menu appears.
   Select the adapter you want to test.

3  From the Main Menu, select Test Adapter.

4  From the Test Adapter Menu, select Test Adapter.

   This runs a series of tests that make sure the adapter is functioning
   properly. It also runs tests that make sure the cabling, connector,
   and network are functioning properly. If a test finds a problem, it
   displays the results and possible solutions.

   You can also run a continuous network test or set up your computer as
   a network responder.

5  Repeat steps 3, 4 and 5 for each EtherExpress PRO/100 Smart adapter
   installed in the computer.



*  Third-party trademarks are the property of their respective owners.