ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
     ³ Install Windows 95 Device Driver for UM8886B PCI-Bus IDE Controller³
     ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ

    Notes:
	  UMC86B.MPD -- UM8886B PCI IDE Device Driver for Windows 95
	  UMC86B.INF -- Setup Information File for UMC86B.MPD

	  These two files must be located on the same directory of
	  the install floppy diskette.


    Installation:
	  If you want to install UM8886B PCI IDE device driver for
	  Windows 95, please follow the steps below.

       1. Check your system requirements, Windows 95 must be fully installed
	  on your system.

       2. Remove IDE device drivers in the AUTOEXEC.BAT and CONFIG.SYS files,
	  especially any drivers that control ATAPI CD-ROM.

       3. Remove the default installed IDE device drivers.

	  I. Open the Control Panel.

	  II. Invoke the System box.

	  III. Click on the Device Manager button.
	       A list of the system devices will be displayed.

	  IV. Click on the Hard disk controllers record. There may have
	      two cases.

	      Case 1, there should have three instances listed:

	       * Primary IDE Controller (single FIFO)
	       * Secondary IDE Controller (single FIFO)
	       * Standard Dual PCI IDE Controller

	       Please go to step V for case 1.

	      Case 2, there should have two instances listed:

	       * Standard IDE/ESDI Hard Disk Controller
	       * Standard IDE/ESDI Hard Disk Controller

	       Please go to step VI for case 2.

	  V. Remove the Standard Dual PCI IDE Controller.
	     1. Select the Standard Dual PCI IDE Controller.
	     2. Click on the remove button.
	     3. Select Yes when prompted to remove this controller.
	     4. go to step VII

	  VI.Remove the Primary & Secondary Controller.
	     1. Select the second instance of the Standard IDE/ESDI Hard
		Disk Controller.
	     2. Click on the remove button.
	     3. Select Yes when prompted to remove this controller.
	     4. Select the remaining instance of the Standard IDE/ESDI Hard
		Disk Controller .
	     5. Click on the remove button.
	     6. Select Yes when prompted to remove this controller.
	     7. go to step VII

	  VII. Select Yes when prompted to re-start Windows 95,
	       and restart Windows 95.

       4. Windows 95 will report a Standard Dual PCI IDE Controller or
	  Standard ESDI/IDE Controller has been detected in the system.
	  Select driver from disk provided by hardware manufactures.

       5. Insert the folppy diskette containing the driver files into
	  the floppy drive.

       6. Choose OK to load the driver from the floppy drive.

       7. Specify the full path of the drivers, and then choose OK.

       8. Select Yes when prompted to re-start Windows 95.

	  After installation, the UMC86B.MPD is stored in the
	  c:\<Windows 95 directory>\System\IoSubsys directory.