3.0.2.2
  - Installation procedure changed;

3.0.2.1
  - Maxim 1617 support added (CPU temp. sensor for some QDI boards)

3.0.2.0
  - bug in fan readings for LM80 fixed;
  - default nominal values changed (for P-II): Vcore=2v; CPUcomp=15 degrees;
  - SIS 5591 support added (beta-release!)

3.0.1.4
  - Ability to read slow-RPM fans added;

3.0.1.3
  - QDI made MBs are supported now (LM80 sensor);

3.0.1.0
  - All/Warning data can now be logged in files;
  - custom wav/application can be launched instead of warning message popup;
  - warning events timeout can be adjusted again;

3.0.0.2 Shareware version
  - min/max values for the current session are displayed as a hint;
  - Intel-made MBs are supported in registered version;

2.4.0.4
  - bug with second CPU correction value fixed;
  - Tyan Thunder2 S1696Dual is fully supported now.

2.4.0.3
  - Warning message timeout is now measured in seconds and zero by default;
  - Confirmation of exit added;

2.4.0.1
  - Ability to select LM75 addresses added;
  - Temp. sensors captions can be altered;
  - Refresh interval is adjustable now;
  - Individual temperature correction allowed for each sensor;
  - Soyo mainboards are supported now;

2.3.0.1
  - Second CPU temp. sensor data visible again;
  - Core2 voltage grayed out for uniprocessor systems;
  - MBs with Winbond chip wired only to ISA are fully supported;
  - Supermicro MBs are supported now;

2.2.0.3
  - Second CPU data are visible under Windows NT with multiprocessor support only;
  - Form layout compacted for single CPU and only two fans;
  - Program can work without LM78 on MB with Intel chipsets now;
  - Program works with Winbond 83781 sensors chip;
  - Program works with Asus non-Intel chipset based MBs;

2.2.0.1
  - Main form layout altered;
  - Settings form redesigned;
  - Ability to read 2nd LM75 sensor added;
  - Check of active driver added under NT;

2.1.0.7
  - M/B temp was not displayed in hint for P-II motherboards in some cases;
  - Nominal value for Vcore now can be from 2.0 to 3.5 volts;

2.1.0.6
  - Only one instance of Hmonitor allowed.
  - Hmonitor now works with LM79 (A-Bit BX6 MB)

2.1.0.5
  - Bug fixed (CPU temp. compensation was not restored after restart)

2.1.0.4
  - Ability to display Fahreheit temperatures added;
  - "Large Fonts" support added;
  - Bug with power fan divisor fixed.

2.1.0.2
  - Some internal subroutines are rewritten;

2.0.2.0
  - Warning messages are logged in Windows 95/NT Application Event Log.

2.0.1.0
  - Giveio.sys replaced by new version (Thanks Dale!);
  - Ability to set nominal value for I/O voltage added;

2.0.0.8
  - Only one copy of Settings/About forms allowed;
  - Default value for I/O changed to 3.5V;
