
STEPS TO INSTALL THE RLN
ADAPTER IN THE NETWORK PANEL.
-----------------------------
*  If no NT Networking is
   installed yet, see the
   NO Networking section
   below.

1. Select the Adapter tab
   if not already there.
2. Select the Add button.
3. Select the "Have Disk"
   button.
4. Enter the directory where
   RLN is installed.
5. Select OK
6. Highlite the "RLN
   Dial-up Adapter".
7. Select OK.
8. Close the Network Panel.
   If needed you will be
   prompted to configure
   any protocols.

NO NETWORKING
=============

NOTE: If the NT Networking
      has not been installed
      you will need your NT
      installation disk/CD.

1. Select Yes to Install NT
   Networking.
2. At the Network Setup
   Wizard, select the Remote
   Option if you want to
   install RAS along with
   RLN. Select the wired
   option if you have
   another NIC to install or
   want to install RLN only.
3. To install the RLN adapter
   choose the option to select
   from a list of adapters.
4. At the Adapter list select
   the "Have Disk" button.
5. Enter the directory where
   RLN is installed.
   Example: D:\rlnnt
6. Select OK
7. Highlite the "RLN
   Dial-up Adapter".
8. Select OK.
9. Follow the remaining
   instructions.
