                         One And Only Media
                            P.O. Box 218
                       Vauxhall, NJ 07088-0218
                           (908) 964-4546
                       oaomedia@chelsea.ios.com
                  http://chelsea.ios.com:80/~oaomedia


                         All Rights Reserved
                Copyright  1995-97 One And Only Media



W  E  L  C  O  M  E  T  O  M  A  C  R  O  F  O  R  M
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
                                                             1/30/97

                   CONTENTS                  

                   Installing MacroForm.........I
                   Release Notes...............II
                   Feedback...................III


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~


I. INSTALLING MACROFORM
---------------------------------------------------------------------
IMPORTANT! Make sure that Modeler is not running before you attempt
to install MacroForm.  When you are sure that Modeler isn't running,
do the following:

	1. Double-click on the Setup.exe icon on this disk. 

	2. Follow the instructions when prompted.

.....................................................................
Note:

	a. The NewTek directory on the system which holds Modeler is the 
installation directory.  For example, if your copy of Modeler is in your 
C:\NewTek\Programs directory, your installation directory is C:\NewTek.

	b. You are no longer required to add the MacroForm plugins and 
function keys to Modelers interface.  The installation will perform 
these operations for you by modifying Modelers config file (lwm.cfg) in 
the \NewTek\Programs directory.  Although you can cancel this operation, 
it is recommended that you allow the installer do its work.  A copy of 
your original configuration is placed in that same directory; its 
called lwm-B4Mform.cfg.  Rename this file as lwm.cfg in case (God 
forbid) something should go wrong during the installation, or if you 
would like to restore your Modeler function key and plug-in list to 
their original settings.



=====================================================================



II. RELEASE NOTES
---------------------------------------------------------------------
  Although we've tried to be as thorough as possible with the 
  MacroForm manual and software, some things inevitably slip through
  the cracks...

	a. On page 4.19 in the Action Translation Guide, the Tech Notes
	   at the bottom of the page states that "If you lathe an open
	   curve...".  It should read "If you extrude an open curve...".

	b. On page 7.111 in the Illustrated Reference, figures 7.20.87
	   and 7.20.88 are switched.  87 is demonstrating RailStretch
	   with Smoothing On while 88 is demonstrating RailStretch with
	   Smoothing OFF.


=====================================================================



III. FEEDBACK
---------------------------------------------------------------------
  We've worked long and hard on this package and we hope it shows. We
  sincerely hope that you will greatly benefit from reading the book
  and using the software; but, to gauge the effectiveness of this
  package, we welcome any feedback and comments.

  Feel free to contact us via e-mail at oaomedia@chelsea.ios.com or
  by calling (908) 964-4546


=====================================================================



.....................................................................
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

-LM & CM
