  Installation instructions are in the manual and must be followed for
  proper EZNEC operation. On Windows systems, installation requires steps
  in addition to running the INSTALL program on this disk. The first step
  for any system is to print the manual.
  
  The manual is ASCII file EZNEC.TXT. It is about 160 pages long. It is in
  ASCII format so that it can be printed on any type of printer and without
  having to have any particular kind of word processor. It will NOT print 
  correctly if printed from a Windows (3.x, 95, or NT) system by using 
  Windows print commands or by loading into Write, Wordpad, Microsoft Word, 
  or any other word processor. Please follow the instructions below so you 
  will have a correctly-printed manual.

  To print the manual:

  Print program EZPRINT.EXE is included on the disk. It functions similarly 
  to the DOS PRINT command, but allows you to print a range of pages at a
  time if desired, rather than the entire manual. However, it does not
  include a print spooler, so if you use EZPRINT you may not be able to use 
  your computer for other purposes until the document has finished printing. 
  DOS and Windows 3.x users can use either EZPRINT or DOS PRINT to print the 
  manual. Windows 95 and Windows NT users can use either EZPRINT or DOS COPY.

  If your diskette drive is B:, substitute B: for A: below.

  Put the disk in drive A:. If you are using Windows 3.x, 95, or NT, go to
  the DOS prompt.
  
  To use EZPRINT:

       All systems:

         Type   A:EZPRINT A:EZNEC.TXT

         To print to a port other than parallel port #1, add /n, where n
         is the number of the port.

  To use DOS PRINT or COPY:

       Window 3.x and DOS-only systems:

          Type   PRINT A:EZNEC.TXT

          To print to a port other than parallel port #1, add /D:LPTn after
          PRINT, where n is the number of the port.
  
       Windows 95 and NT systems:

          Type   COPY A:EZNEC.TXT PRN

          To print to a port other than parallel port #1, substitute LPTn:
          for PRN, where n is the number of the port.

  To install EZNEC, follow the instructions in the INSTALLATION section
  of the manual. NOTE that installation for use under Windows
  (3.xx, 95, or NT) requires steps in addition to running the INSTALL
  program. These steps are described in the manual.

  To replace an existing EZNEC program, follow the installation
  instructions in the manual. During installation, specify for
  installation the directory containing your current EZNEC program
  files. The new files will overwrite the old ones.
