File: SETUP.TXT
Date: 08/01/94


The Wacom drivers on this disk conform to the Pen Windows specs. 
Additionally, if installed properly, they will be compatible with 
programs which made proprietary calls to Wacom's earlier mouse 
driver (including enhancements added by Fractal Design).

Use only WMOUSE.COM version 4.0 or above when you are using these
Windows' drivers.

The setup program on this disk should make the following changes to
your system.ini file. Just as easily you can make the same changes with a 
text editor.

Wacom's Windows 3.0 Mouse replacement driver should not be installed on 
the same com port as the tablet driver. Windows will not boot up if it is.

To install the tablet in Windows 3.1, make sure the SYSTEM.INI contains 
the following line under the [boot] heading.
	[boot]
	   .
	   .
	mouse.drv=WACPEN.DRV
	   .
	   .
	drivers=pen mmsystem.dll penwindows

The setup routine adds the words 'pen' and 'penwindows' if 
these  were not previously there. Refernces to other drivers 
on the "drivers=" line (like mmsystem.dll) do not come from Wacom.

Under the [drivers] heading put\add:
	[drivers]
	    .
	    .
	pen=wacom.drv
	penwindows=penwin.dll

The files wacom.386, wacom.drv, WACPEN.DRV, penwin.dll and wacom.cpl  
must be expanded and then should be copied to the system subdirectory 
of Windows. Use the MS-DOS program EXPAND.EXE to do the expansions. 

the tablet will also emulate a mouse even without penwin.dll loaded.

In order to use a pointing device in Windows in addition to the 
tablet, copy the windows mouse driver for the other pointing device
to 'oldmouse.drv' in the Windows system subdirectory. The virtual driver
for this pointing device should be on the right side of the
"mouse=" line in the [386Enh] section of system.ini
  
Under the [386Enh] section put\add:
	[386Enh]
	   .
	   .
	device=wacom.386

There must be no other pen drivers listed on the right side of any
"device=" lines of this [386Enh] section. Windows will not boot up
in enhanced mode otherwise.

Add a new section to your system.ini file.  -- [Pen Driver]

If your Wacom tablet is hooked up to com2, add the 
following line to the [Pen Driver] section of SYSTEM.INI.

	[Pen Driver]
	ComPort=2

If you are leaving your tablet dip switches at factory defaults   
add the following line to the [Pen Driver] section of system.ini
	[Pen Driver]
	   .
	   .
	9600baud=1

