   Workstation for DOS IPX Client

   NetWare* DOS IPX Client Driver Installation Notes for Intel's 
   EtherExpress(TM) PRO/10 LAN Adapter
   =============================================================
  
   Location of Driver:     \NWCLIENT\IPX.COM 

   Quick Installation
   ------------------
      Use the Auto Installation option in the SoftSet2 program. 


   Sample Configuration Files
   --------------------------
      AUTOEXEC.BAT:
         IPX
         NETX
  
  
   General Installation
   --------------------
      Note: If you are also running Windows* for Workgroups, please see the 
            Hints and Tips section below for important information.
      
      1. A pre-generated IPX.COM comes on the disk and will work with any 
         configuration that the lan adapter is set at.
         

      2. Copy IPX.COM and NETX.EXE from the NWCLIENT directory to your boot 
         disk, and add them to the AUTOEXEC.BAT or login batch file.


   Hints and Tips
   --------------

      1. If the workstation cannot find the file server:
   
         The pregennerated IPX.COM on the diskette is configured for 802.3 
         frame type.  Be sure that 802.3 frame type is loaded and bound at 
         the file server.  This is especially true with a NetWare 3.12 or 
         4.01 file server since 802.2 loads by default, not 802.3.

      2. If workstation requires 802.2 frame type:
   
         IPX.COM only supports 802.3 and Ethernet_II.  You must use the ODI 
         driver for 802.2 frametype.  

      3. If workstation requires Ethernet II frame type:
 
         Use Novell's ECONFIG program to change the IPX.COM to Ethernet_II 
         frame type.

      4. If installing Windows for Workgroups and Novell NetWare:

         You must install the DOS ODI client driver, the IPX.COM driver 
         will not allow support for Windows for Workgroups.  

         To install proper driver support for Windows for Workgroups and 
         Novell NetWare on the same workstation, follow these steps:
         
         1. Set up the workstation with the DOS ODI client driver.
         
         2. Load the ODI driver and login to your NetWare server.
         
         3. Start Windows for Workgroups and set up the driver for the
            EtherExpress PRO adapter by following the instructions shown in 
            the Windows for Workgroups installation document.  When the 
            driver is chosen, Windows for Workgroups will detect the ODI 
            driver is already loaded and automatically install the 
            appropriate support.
   

   * Third-party trademarks are the property of their respective owners
