   Windows NT 3.1

   Microsoft Windows* NT v3.1 Installation Notes for Intel's 
   EtherExpress(TM) PRO/10 LAN Adapter
   =========================================================

   Location of Driver:     \NT\31\EPRONT.SYS


   General Installation    
   --------------------
  
      If you have a Plug and Play BIOS, make sure you DISABLE Plug and Play
      on your adapter using SoftSet2 (Advanced Options menu). NT may not be 
      able to find your adapter if Plug and Play is enabled. NT doesn't 
      support Plug and Play (it doesn't support a Configuration Manager.)


      1.  Use either SoftSet2 or FlashSet to configure the adapter before
          running NT setup. Make sure you write down the IRQ and I/O address
          settings. 
      
      2.  In NT, select the Network icon in the Control Panel, and then
          select Add Adapter.

      3.  A list of available adapters displays. The EtherExpress 
          PRO/10 adapter driver doesn't ship with NT 3.1, so select
          "<Other>" at the end of the list.

      4.  Insert the EtherExpress PRO/10 adapter disk and press enter.

      5.  Enter "A:\NT\31" for the path. This is where the driver EPRONT.SYS
          and setup file OEMSETUP.INF are located.  

      6.  Change the adapter settings to agree with the settings in SoftSet2
          or FlashSet. 
          
          The Interrupt value should match the IRQ value, and the I/O Port 
          should match the I/O address. DO NOT change the I/O Channel 
          Ready setting. 

      7.  NT Setup then performs the binding process. If you installed any 
          additional network software options (for example, Client Services
          for NetWare), you may be prompted for specific information for 
          these options.

      8.  Restart NT when prompted. Use the File Manager to connect to 
          the network.



   * Third-party trademarks are the property of thier respective owners.
