   LAN Server 3.0

   LAN Server 3.0 Installation Notes for Intel's 
   EtherExpress(TM) PRO/10 LAN Adapter
   =============================================

   Location of Driver:     \OS2\EPRO.OS2   (OS/2 driver)
                           \OS2\EPROEOS2.NIF
                           or
                           \DOS\EPRO.DOS   (DOS driver)
                           \DOS\EPROEDOS.NIF


   Sample Configuration Files
   --------------------------

      PROTOCOL.INI (will include):

          [EPRO_NIF]
             DriverName = EPRO$
             IOADDRESS = 0x300
  

   General Installation under OS/2 
   -------------------------------

      1. Verify the I/O Address of the EtherExpress PRO adapter by running 
         SoftSet2.

      2. This installation does not use OS/2 Extended Services.  These 
         steps apply to both the file server and the workstation.  After 
         installing OS/2, follow the below steps prior to installing 
         LAN Server 3.0 or the workstation requester.
  
      3. Copy EPRO.OS2 and EPROEOS2.NIF from the EtherExpress(tm) PRO LAN 
         adapter disk to the C:\IBMCOM\MACS directory.

      4. Install LAN Adapter and Protocol Support (LAPS) from an OS/2 
         window.

      5. After installing the software, select configure LAN transports.  
         The EtherExpress PRO will appear in the LAN Adapters window.  
         Select the necessary protocols and save the configuration.

      6. Exit LAPS, shutdown the system and reboot the computer.  The 
         complete PROTOCOL.INI file will be created and put in the C:\IBMCOM 
         directory.  The CONFIG.SYS and AUTOEXEC.BAT files will be updated. 


   General Installation under DOS 
   ------------------------------

      1. Run DXMAID from the IBM OS/2 LAN Server v3.0 LAN Requester; LAN
         Support Program (LSP).

      2. Complete environment information according to your needs.

      3. Specify directory where EPRO.DOS and EPROEDOS.NIF are located.  See
         driver location listing above for location on adapter disk.

      4. When DXMAID is completed, run INSTALL from DOS LAN Requester 
         diskette. 
         Note: LAN Requester needs DOS 3.3 thru 5, but if you are on 
         DOS 6.0 or above, SETVER can be used on the EXE files on the DOS 
         LAN Requester disks. 
