   ISA adapters in EISA slots

   Installing an EtherExpress(TM) PRO/10 ISA adapter in an EISA slot
   =================================================================

      You can install the EtherExpress PRO/10 ISA adapter in an
      EISA slot. Installation requires three steps:
         
      1.  Put the adapter in the computer.
         
      2.  Select the configuration settings from the 
          EISA Configuration Utility (ECU).
      
      3.  Configure the adapter with SoftSet2.

   
   Put the adapter in the computer
   ===============================
      
      Follow the procedure on page 3 of the Installation Guide, 
      installing the adapter in an EISA slot instead of an ISA slot. 


   Select the configuration settings from the ECU
   ==============================================
      
      1.  Restart the computer. If you have a flash-equipped
          adapter, exit the flash program. 

      2.  Run the most recent version of the EISA 
          Configuration Program for this computer.

      3.  From the Main menu, select the command for 
          configuring the computer. When prompted, insert
          the Intel Configuration disk. The configuration
          file for the adapter is !INT1030.CFG. 

      4.  Write down the settings you want to 
          assign to the EtherExpress PRO/10 adapter and exit
          the program. (You must choose settings that aren't
          used by any other device in the computer.)

   
   Configure the adapter with SoftSet2
   ===================================
      1.  Insert the Intel configuration disk into a drive,
          switch to that drive, and type SOFTSET2.

      2.  From the Main menu, select CHANGE ADAPTER 
          CONFIGURATION. 

      3.  Select the configuration settings you chose in the 
          EISA configuration program. 

      4.  Continue with the setup procedure on page 6 of the
          Installation Guide. 

