@DefineDisk

	@Label = "DISK 5 OF 8"

   @If ( 'D' [= @Group )

       @BeginLib DRV1.RED

			@File   *.*	    @Out    \@Subdir\DRV\*.*

       @EndLib

   @Endif

   @If ( 'H' [= @Group )
              
       @BeginLib DCADHELP.RED  
                
           @File   *.*     @Out    \@Subdir\HELP\*.*
        
       @EndLib

   @EndIf

@EndDisk      

@If ( 'E' [= @Group )

   @Chain ("DISK 6 OF 8")

@ElseIf (( 'E' [= @Group ) ||
         ( 'V' [= @Group ))

   @Chain ("DISK 7 OF 8")

@ElseIf (( 'V' [= @Group ) ||
         ( 'H' [= @Group ))

   @Chain ("DISK 8 OF 8")

@EndIf

@Finish

   @If ('V' [= @Group)
   	@Mkdir ("@OutDrive3:\\@Subdir3\\VTM")
   @EndIf

   @Cls

	@ChDrive@OutDrive
        @ChDir "@Subdir"


   @If ('V' [= @Group)
       @If (!(100 [= @Option))
@Rename("@OutDrive3:\\@Subdir3\\CLIPPL64.EXE","CLIPPL.EXE")
@Rename("@OutDrive3:\\@Subdir3\\RDRPL640.EXE","RDRPL.EXE")
       @Else
@Rename("@OutDrive3:\\@Subdir3\\CLIPPLEM.EXE","CLIPPL.EXE")
@Rename("@OutDrive3:\\@Subdir3\\RDRPLEMS.EXE","RDRPL.EXE")
       @EndIf

   @EndIf
   @If (('A'[=@Group) || ('D'[= @Group) || ('U'[= @Group ))
        The DataCAD Configuration Utility will now be run.  This is
        where you should select your display device, digitizer (if any),
        plotter, etc.

        @If (('A'[=@Group) || ('D'[= @Group ))
           @Mkdir ("@OutDrive:\\@Subdir\\LYR")
           @Mkdir ("@OutDrive:\\@Subdir\\PLT")
           @Mkdir ("@OutDrive:\\@Subdir\\SYM")
           @Mkdir ("@OutDrive:\\@Subdir\\TPL")
        @EndIf
	@pause
   @If (@Spawn ("CONFIG"))
   @EndIf
   @EndIf
   @Cls

        The installation has been successfully completed.
        To run DataCAD, type RUNDCAD at the DOS prompt and
        press <Enter>.

	Note:  Please be sure you have installed your mouse
	       manufacturer's supplied driver according to
	       their instructions prior to running DataCAD.

	Thank-you for choosing DataCAD!

	@pause
@EndFinish
