                 FIDELITY RETIREMENT PLANNING THINKWARE 
                            README.TXT File

If you have difficulties running FIDELITY RETIREMENT PLANNING THINKWARE,  
here are some hints on solving your problem.

1)  You receive the message:

        Sorry, you do not have enough memory to run the program.
                At least 461K of free memory is needed.
           Please press any key to return to the DOS prompt.

    This is informing you that there is not have enough free memory available
    to run FIDELITY RETIREMENT PLANNING THINKWARE.  The program requires a
    minimum of 461K of RAM to run.  First you should check to see if your  
    system is equipped with more than 461K of RAM.  If it does have more than 
    461K of RAM, then most likely you have one or more memory resident programs
    installed.  In this case, remove some of these programs (by modifying your 
    CONFIG.SYS or AUTOEXEC.BAT files) and try running the program again.


2)  Your system freezes when running FIDELITY RETIREMENT PLANNING THINKWARE:

    This is most likely due to an incompatibility with a memory resident 
    program.  Unload your memory resident programs one at a time and try
    to run the program again to see which program is not compatible with
    FIDELITY RETIREMENT PLANNING THINKWARE.

3)  If you are installing FIDELITY RETIREMENT PLANNING THINKWARE on a computer
    containing a CD-ROM drive you may receive error messages during the 
    install procedure.  These error messages are due to the fact that there is
    no CD in the drive.  This is not a problem and you can press ENTER at each 
    message to continue with the installation procedure.
    
4)  If you receive the message "Sorry, you do not have enough memory to 
    print.  At least 490K free memory is needed.", you have attempted to 
    print your plan but there is not enough conventional memory available.
    The print routine requires more memory than the rest of the program.
    As a result, you will need to have at least 490K of free conventional
    memory to be able to print your plan.  To free up more conventional
    memory, modify your AUTOEXEC.BAT and CONFIG.SYS files and remove any 
    TSR's from memory.
