MITSUBISHI 700

NOTES:  This is a single NAM unit.
        The ESN prefix is 134 decimal, 86 hex.
        Mitsubishi: 708-860-4200

PROGRAMING

1.  Turn power on by pressing PWR for at least one second.

2.  Wait for wake up cycle to end and display to clear.

3.  Within ten seconds press and hold the CLR key while entering
    3 1 1 1 9 1 7.

4.  The SEND key is used to store and increment each step.

5.  The END key is used to complete and exit programing at any time.

PROGRAMING DATA

STEP#    #OF DIGITS/RANGE    DISPLAY         DESCRIPTION

01       10 DIGITS           MUTE            MIN (AREA CODE & TEL#)
02       4 DIGITS            SEC             SECURITY CODE
03       00000 - 32767       Sid             SYSTEM ID
04       0 OR 1              LU              LOCAL USE MARK
05       0 OR 1              E               MIN MARK
06       333 OR 334          IPCH            INITIAL PAGING CHANNEL
07       2 DIGITS            ACC             ACCESS OVERLOAD CLASS
08       0 OR 1              PrEF            PREFERRED SYSTEM
09       2 DIGITS            GI              GROUP ID (10 IN USA)
10       0 OR 1              EE              END TO END (DTMF) DIALING
11       0 OR 1              rI              ROAM INHIBIT
12       0 OR 1              Ab              A/B SYS SELECT
13       0 OR 1              AL              AUTO LOCK
14       0 OR 1              bO              3 WATT BOOSTER

NOTES:

Install lock code with phone out of programing mode, press
FCN STO SSSS LLL CLR, where SSSS is the security code, and LLL is
the new lock code.

LOCK: F 2.  UNLOCK: Enter three digit code.

SYSTEM SELECT: F 1 to display current, then one of the following to change:
0 = Pref/non pref, 1 = Non pref/pref, 2 = Home only, 3 = Pref only, 4 = Non
pref only.
Press CLR to store/exit.